Sometimes, Netgear users face issues while connecting their devices to the wifi networks due to different reasons. Similarly, various Netgear extender users complain that their range extenders are not connecting with the existing routers, indicating the need for a new router connection. If you are also facing such issues and want to know How to Connect Netgear WiFi Extender to New Router, then, walk through this blog post!
Different Ways to Connect the Netgear Extender to New Router
However, you can connect your Netgear range extender to a new wifi router in two ways, i.e., via the WPS button and web GUI. Before you begin, you must know that you need to reconfigure your device again if you Connect Netgear Extender to New Router. So, check the below sections for the stepwise procedures for the same.
How to Connect Netgear WiFi Extender to New Router Via Web GUI?
- Initially, reset your extender by pressing and holding the reset button for 10 seconds.
- Then, let your extender complete rebooting and restart again.
- Now, power on your device and connect your PC to its default SSID.
- Hereon, open any web browser and enter the mywifiext.net web address in the URL bar.
- After that, log into your range extender’s admin panel.
- Then, go to its basic home page and tap on the ‘New Extender Setup’ button.
- Now, create an account by entering the required details.
- Here, you will pop up with a message to choose AP/WiFi Range Extender mode.
- Select the repeater mode and it will now search for the available wifi network.
- Then, select your router’s SSID and connect it by entering its password.
- Then, customize the wireless settings (SSID and password) on your extender.
- After that, connect your PC to the extender’s new wifi network created above.
- Tap on ‘Continue’ to complete the setup.
- Finally, you learned How to Connect Netgear WiFi Extender to New Router.
Connect Netgear Extender to New Router Via WPS Button
- Initially, locate the WPS button on your extender and router.
- Then, press and hold this button on the router for 5 seconds.
- Wait for the WPS indicator to blink and initiate the connection.
- Within 60 seconds, press and hold this button on the Netgear extender for 5 seconds.
- Now, wait for around 5 minutes till the WPS light stops blinking.
- Then, check the link LED on the router.
- If it is ON, then your extender connects to the router successfully.
- At last, move your devices to a preferred location to enjoy an extended wifi signal.
Quick Tip: You can’t use the WPS button method to connect your Netgear extender to the router using WEP encryption.
In Conclusion
Overall, this guide provides all-in-one details on How to Connect Netgear WiFi Extender to New Router through quick instructions. We hope you now completely understand this procedure and enjoy optimal wifi signals at your home.